TESTING FACILITIES

ROTEX manufacturing units have the best testing facilities to thoroughly check the product suitability to the design & performance requirements.
Most of the facilities are in-house, located in the manufacturing premises.
Some of the special tests are outsourced.

Following tests can be offered by ROTEX:
A.   For Solenoid Valves (Fluid Control System)
      Routine Test:
        Body & Seat leakage test
        Pick up & Drop down test
        Di-electric test
        Insulation resistance test

      Type Test:
        Cyclic test
        Flow Test
        Thermal Aging
        Helium leak test
        Hydro Test
        Vibration test
        Burn in test
        Surge test
        Temperature rise test
      (Note: The type tests are not routine tests & may be
      chargeable depending upon the order quantity & value)

      Special Tests offered:
        Radiation Qualification
        LOCA Qualification
        Seismic Qualification as per IEEE 323, 344 & 383
        Environmental Qualification
        Enclosure Certification
        Corrosion Test
        Radiography
        Intra Granular Corrosion Test
        Material Qualification Test etc.
      (Note: The special tests are not routine tests & may be
      chargeable depending upon the order quantity & value)

B.   For Valve Automation Systems:
      Pneumatic Actuators:
      Routine Test:
        Leakage Test
        Operation Test
        Min. operating Pressure

      Test Type Test:
        Torque Output Test
        Cyclic Test
        Response Time Test

      Special Test:
        Radiation & LOCA qualification
        Vibration Test
        Seismic Qualification as per IEEE 323,344 & 383
        Environmental Test

      Valve Automation Systems:
        Body & Seat Hydro Test
        Seat Leak Test
        Operation Test
        Cyclic Test
        Accessories Testing for Limit Switch,
        Solenoid Valve, Positioner & Position Transmitter